Fuse box plug pin layout

Forum › Forums › Tractor Troubleshooting › Fuse box plug pin layout

Viewing 9 reply threads
  • Author
    Posts
    • November 5, 2011 at 7:05 am #30444
      TGS
      Participant
        • Offline

        I am searching for the fuse box  plug  pin layout  . I have a wireing layout and want to get then  battery light and oil light working on my Cluster . There is not wire on the wiring harness  for the lights  I know it  number 41  but  can not find where 41  would be on the  plug to match it to the wire on the fuse box.

             it would be good to have  as it the little tags come off the wire could always look at the pin layout to see what that are

         Thanks

            Thomasreadin

      • November 12, 2011 at 11:25 am #33666
        circleg
        Participant
          • Offline

          Go to http://www.circlegtractorparts.com

        • November 12, 2011 at 6:09 pm #33679
          TGS
          Participant
            • Offline

            They have the pin layout there ?

                     I looked for it there but did not see it  in fact  you should find it and send it to me as I purchased  my tractor for you and the wiring Harness that on my tractor does not have the wries to make the dash battery and oil warning light work

          • November 12, 2011 at 10:23 pm #33680
            oldfart2
            Participant
              • Offline

              TGS

               HI. You really should contact the seller in private, to try to work out a problem. I'm sure they will try to help you!

            • November 13, 2011 at 8:55 am #33681
              TGS
              Participant
                • Offline

                Yes maybe I should have

                    but if you see from my question I was looking for info not to buy a part and when he reply to to parts department  I told hime how I felt.

                 I did not make this post to complain about anything .

              • November 13, 2011 at 11:44 am #33682
                RichWaugh
                Participant
                  • Offline

                  I'm confused – didn't you get the same question asked and answered on another forum?  The person who answered the question stated that he had drawn the diagram himself, so it is evidently not available elsewhere, is it?

                • November 13, 2011 at 12:03 pm #33683
                  Bob Rooks
                  Participant
                    • Offline

                    I have never seen a pinout for any of these tractors. I don't believe they exist in the free world. Doing your own pinout can be done, it just takes time and patience. Or you can contact Jinma directly to see if one is actually available.

                    Account deleted.

                  • November 13, 2011 at 4:37 pm #33684
                    TGS
                    Participant
                      • Offline

                      Hard to make one when wire are missing

                          if you want one Tractorbynet   was question  as here

                    • November 13, 2011 at 5:39 pm #33685
                      Bob Rooks
                      Participant
                        • Offline

                        Does your voltage regulator have a red LED that's lit when the engine is running?

                        Account deleted.

                      • November 13, 2011 at 5:46 pm #33686
                        TGS
                        Participant
                          • Offline

                          no it does not  it is a 5 pin one

                             I am trying to get the battery light hooked up that whay I was seeking the pin layout

                      • Author
                        Posts
                      Viewing 9 reply threads
                      • You must be logged in to reply to this topic.