LW6 Swing arm leak

Forum Forums Tractor Implements LW6 Swing arm leak

Viewing 3 reply threads
  • Author
    Posts
    • #30612
      postgenerate
      Participant
        • Offline

        Howdy,

        If this is redundant sorry.  I have searched and didn't find my answer.  I will honor any instruction I receive.  I have a 2007 LW6 backhoe with a 3 pt hitch on my jinma 354 with a pto pump.   It all works except the swing arm on the right side spews massive amounts of fluid through this hole in the brass fitting on the end of the right cylinder in in the picture.   I am trying to understand what the problem might be.  it only spews when moving the swing arm lever left or right.  All advice is appreciated.Swing arm leak

      • #34852
        Bob Rooks
        Participant
          • Offline

          Welcome to CTOA Post,

          I used to own a LW-6.

          The swing cylinders are single acting. The brass fitting in the end is an air filter to keep dirt and debris out of that end of the cylinder.

          What has happened in your case is the cup seals on the piston have blown, letting oil by, and collecting in the unused portion of the cylinder.

          Time to repair or replace that cylinder. My guess is that you were using boom swing to move dirt with the side of the bucket – that's a no-no with these particular hoes. Kits are available through Circle-G and various other dealers that support this site

          Account deleted.

        • #34856
          postgenerate
          Participant
            • Offline

            Thanks Bob,  that sounds totally logical.  And I never intentionally move dirt sideways but I am not very coordinated with the bucket it does take alot of sideways force.   I have a heck of a time getting the cylinder off but I have just dismantled it in place.  I see a disintegrated seal.  I ordered several seals (cirgle g, sorry keno)  that I think are right and a few slightly larger and smaller just so I have it right.    we can close this ticket. problem solved.  thanks again!

             

              

          • #34857
            Bob Rooks
            Participant
              • Offline

              I know how violent those controls can be. Try slowing your engine down some. Another trick you can do is put restrictors in the hydraulic hose couplings, you don't lose any power, just the erratic movements. Many have done this and enjoyed the success.

              Account deleted.

          Viewing 3 reply threads
          • You must be logged in to reply to this topic.