Hydraulic Seals

Forum Forums Tractor/Dozer Engines Hydraulic Seals

Viewing 7 reply threads
  • Author
    Posts
    • #30690
      gabmuks
      Participant
        • Offline

        Hello and good day to all.

        I have hydraulic hose fittings on my Chinese tractor for my FEL.

        One particular fitting has always leaked because I don't know

        what kind or where to purchase the correct seal.

        I don't even know what it should look like since there was never one installed.

        I will try to post pictures of the hose connections.

      • #35288
        gabmuks
        Participant
          • Offline

          Still trying to post photos. No luck.

          I did upload them here I think.

          but don't know where they went.

        • #35289
          gabmuks
          Participant
            • Offline

          • #35290
            Affordable
            Participant
              • Offline

              Those fittings are called ORFS  ( O-Ring Face Seal)  ,Ronald at Ranchhand supply has some fittings to replace these with and can also make you hoses.Give him a try 757-650-9124

               

              Tommy

              Affordable Tractor Sales

              “Your Jinma Parts Superstore”

              http://www.affordabletractorsalesco.com

            • #35291
              quicksandfarmer
              Participant
                • Offline

                It looks like the O-ring is missing. It should go inside that groove in the male piece. I'd go to Harbor Freight and get a box of metric O-rings and see if one fits.

              • #35292
                gabmuks
                Participant
                  • Offline

                  Thanks much Tommy and Quicksand.

                • #35294
                  ronjin
                  Participant
                    • Offline

                    I am not an expert, but it looks to me that that is the type of fitting that takes the 'rubber-wrapped washer'.  Can't remember what it is actually called.

                    RonJ

                    ronjin

                  • #35242
                    DavidPrivett
                    Participant
                      • Offline

                      I think that either would work as long as you can get compression between the 2 surfaces but the flat rubber seal would be my first choice.

                  Viewing 7 reply threads
                  • You must be logged in to reply to this topic.