ZL20

Forum › Forums › Tractor Operation And Maintenance › ZL20

Viewing 5 reply threads
  • Author
    Posts
    • September 7, 2013 at 4:37 pm #30815
      wsee
      Participant
        • Offline

        Greetings trying to learn the site been a few years anyway trying to remove my ZL20 to adjust my clutch… I know there use to be a procedure or article on it but I searched and can not find anything…….. so is this so comercialized that i can not find a thing on a zl20??????????????  is it the korean market now????????? just say'en

      • September 10, 2013 at 9:48 am #36395
        Affordable
        Participant
          • Offline

          Try this under Jinma Maint.

           

          http://johnstractor.homestead……chAdj.html   

          It should help you

           

          Tommy

          Affordable Tractor Sales Co.

          “Your Jinma Parts Superstore”

          http://www.affordabletractorsalesco.com

        • September 10, 2013 at 3:59 pm #36396
          Tinbender
          Participant
            • Offline

            It's something about this site and http tags. Everything is missing between http://johnstractor.homestead   and   chAdj.html

            http://www.johnstractor.homestead.com will get you on the site.

          • September 23, 2013 at 4:14 pm #36422
            wsee
            Participant
              • Offline

              Thanx for the info I forgot abot that site anyway thru trial and error I removed that fel.    Had this tractor for ten years and it is the first time the fel has been off…. I really do appreciate the help and support….

            • September 23, 2013 at 4:51 pm #36423
              RichWaugh
              Participant
                • Offline

                I took mine off a couple of years ago and it was not fun.  The published method works, as long as you have a level, smooth, hard surface to work with – I don't.  I finally used my engine hoist/shop crane to hold it up so I could back the tractor out of it.  I hope I never have to do that again.

              • September 25, 2013 at 11:21 am #36424
                tractorpilot
                Participant
                  • Offline

                  I adjusted my clutch a couple years ago on my 284 but I only removed the left bracket by the bell housing to get access to the clutch.It worked fine with the loader at rest on the floor.

              • Author
                Posts
              Viewing 5 reply threads
              • You must be logged in to reply to this topic.