Forum › Forums › Tractor Troubleshooting › No Steering, Sort Of.
- This topic has 6 replies, 2 voices, and was last updated 10 years, 3 months ago by Affordable.
-
AuthorPosts
-
-
July 7, 2014 at 3:51 pm #30905
Hello all, newby here.
I recently purchased a 2007 Agracat 3720 Magnum. Through searching the internet and looking at tags on the side of the motor I think I have the equivalent of a Jinma 304. It has a diesel engine (3Cyl), model TY3951T which I think is a Yangdong Y395. The tractor has a FEL, and TPH, with 2 spd PTO. I have not changed any fluids yet but am about to.
The problem I have that just started is when I am working the tractor and want to turn the steering wheel turns and turns and turns but I go straight, eventually it will start turning but only after about five revolutions of the steering wheel. FEL works fine, TPH sit up high and does not droop. My plan is the replaced hydraulic filter on lower side of engine and refill with fresh fluid. Will this work or is something broke / worn out?
Thank you in advance,
Rcimp
-
July 8, 2014 at 4:57 am #37078
The steering cylinder is bypassing internally, you will need to rebuild that cylinder or replace it. We have new cylinders as well as rebuild kits, give us a call 979-865-4002
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
-
July 14, 2014 at 8:35 pm #37087
Thank you for the reply. I will be in contact with you soon. I think I will try the rebuild kit first.
Rcimp -
July 15, 2014 at 5:46 am #37088
Your tractor is the same as the 300 series Jinma with the TY395I engine
If you do not have parts or engine parts books we have them also
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
-
July 16, 2014 at 8:21 am #37093
Placed my order this morning. Ordered the cylinder rebuild kit and the three manuals. Hope the rebuild is all it needs. Thanks Tommy
Rcimp
-
July 22, 2014 at 10:49 am #37101
Hi Tommy,
I received my books for my tractor and the rebuild kit for my steering cylinder. However, I could not find a parts breakdown of the cylinder in any of the books and I did not receive any directions as to which seal goes where in the cylinder. Are there any directions or is it obvious where the seals go once I break it down? Just want to be sure I get it right.
Thanks,
Rcimp
-
July 22, 2014 at 3:01 pm #37103
It's pretty straight forward on where the seals go,there may be a extra o-ring or seal due to this kit fits a few different cylinders
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
-
-
AuthorPosts
- You must be logged in to reply to this topic.