- This topic has 9 replies, 4 voices, and was last updated 4 years, 9 months ago by
.
-
Posts
-
-
Hello again I am trying to determine what the oil pressure should be on my Jinma 354. I am confused by the water temperature readings the gauge from left to right reads 100-80-40> Not sure how to read it. When I start the tractor the gauge reads 100 but doesn’t move. Don’t know if the gauge is working or what is going on. I have the old single gauges and just put new ones on from Affordable tractor sales. Thomas and Tommy are great folks as most of you already know but I need help. One other thing to note is that I have power at the gauge and power at the water sending unit, could either the sensor or gauge be defective ? Thanks
-
call Tommy back and ask them what the ohm reading should be on the sending unit cold, you will need a ohm meter to read it. The sending unit just uses one wire if I remember right so you will be reading from the post to the body of the sender(ground). if he knows the hot ohm reading you can heat up some water and immerse the unit to check the upper end also. I suppose you can just heat up some water and see if the ohm reading changes that would put you towards the gauge or the wiring to it .
-
That’s a first for me. I’ve seen gauges from all over the world, but never one that reads from right to left. That said, there are scripts that read from right to left: Arabic, Hebrew, N’ko (Mandekan), Syriac (Assyrian, Modern Aramaic Koine), Thaana/Thâna (Dhivehi/Maldivian), Tifinar (Tamashek), and Urdu. But I doubt that gauge has any relationship.
Account deleted.
-
-
-
Under Service & Repairs
Temperature Sensor FailureTemp/Resistance Curve values
-
-
-
-
-
- You must be logged in to reply to this topic.