Forum › Forums › Tractor Modifications › new air filter source for compressor
- This topic has 10 replies, 2 voices, and was last updated 5 years, 1 month ago by DavidPrivett.
-
AuthorPosts
-
-
September 17, 2019 at 8:35 am #49102
Well after of years not doing it I took off the factory air cleaner for the on board compressor and piped it into the air filter system for the engine . It was so easy I do not know why I did not do it earlier , Thanks Bob for this modification suggestion.
-
September 17, 2019 at 8:05 pm #49103
My memory has failed me. What was this on?
Account deleted.
-
September 18, 2019 at 9:27 am #49104
My 50 hp Foton it came from China with a compressor for air brakes ,I guess they use them in Europe. Anyway it had a junky air filter and you suggested that I relocate the suction side to the air filter that the engine uses.
-
September 18, 2019 at 10:36 am #49105
Now I remember. I don’t know why they didn’t do that at the factory. The mod isn’t that difficult.
Account deleted.
-
September 19, 2019 at 7:08 am #49106
Like I say it was so easy , I was done almost before I knew it was over. hahahahah
-
October 3, 2019 at 9:11 am #49119
Bob I was given a economy power king tractor it has a hydro lift , a external pump that runs off the engine via belt , it uses a 2 way cylinder with about 1 gal oil(ATF fluid) reservoir. It has no filter , it is a 1975 and seems to work well . Should I add a filter or just leave it alone? I was kinda thinking if I use it more that it has been(which is not much) stuff might start to loosen up and start to move threw the system. Take a WAG.
-
October 3, 2019 at 10:00 am #49120
If it’s like this one, I wouldn’t bother. The system is very small and simple, and your investment is low anyway.
Account deleted.
-
October 3, 2019 at 12:38 pm #49121
yep that is what it is, and good I will leave it alone.
-
October 4, 2019 at 8:31 am #49122
That’s a pretty sweet little machine actually. Has a lot of potential. I’m assuming it has an automotive style dry clutch with that manual transmission. I’m not saying you shouldn’t install a return filter though, because I probably would if it were mine, just because I can.
Account deleted.
-
October 6, 2019 at 9:22 am #49127
it uses the same pressure plate bearing and clutch disc as a farmall cub and a 3 speed trans one version uses 2 trans back to back that make them 9 speed. I think I will pull the hydro tank and look at the bottom for sludge.
-
October 6, 2019 at 10:29 am #49128
I found on ebay a small housing 3/4 inch in and out rated at 15 gpm 25 micron 33 bucks went with that can not hurt ,bottom in reservoir tank not to bad but not to good either and hoses are 50 years old, so this should catch the trash.
-
-
AuthorPosts
- You must be logged in to reply to this topic.