Brake and Clutch lever location on the dozer

Forum › Forums › Bulldozer & Excavator Operation and Maintenance › Brake and Clutch lever location on the dozer

Viewing 2 reply threads
  • Author
    Posts
    • January 26, 2017 at 8:14 pm #46647
      chuckinnc
      Participant
        • Offline

        Dozer turns to right easy but really have to press really hard to turn left so I am trying to adjust the turning braked/clutch. It’s a farmpro trac king dozer, similar to all the ty395 engine Chinese dozers.  I don’t have and can’t get a manual so I need to know which lever controls the turning brake and which one controls the turning clutch.

        L/R pedals each pull 2 rods forward when pressed, one rod goes to a horizontal mounted lever ontop the rear axle housing, the other rod pulls a vertical c shaped lever connected just below the horizontal lever, both move forward if either L/R pedal is pressed, need to know which is brake or clutch.

      • January 26, 2017 at 9:18 pm #46650
        Bob Rooks
        Participant
          • Offline

          The rods must be adjusted to the proper timing sequence.

           

          Attachments:
          You must be logged in to view attached files.

          Account deleted.

        • February 1, 2017 at 6:33 pm #46666
          chuckinnc
          Participant
            • Offline

            My pedals pivot point is mounted below the transmission and connect to the rods there, then the pedal arm extend up to the floorboard.  Thanks that’s what I needed I know which is which now.

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.