correct assembly of shift lever into top cover

Forum › Forums › Tractor Operation And Maintenance › correct assembly of shift lever into top cover

Viewing 2 reply threads
  • Author
    Posts
    • November 19, 2011 at 9:14 pm #30455
      donaldl
      Participant
        • Offline

        Hi forum,Just recieved a new main gear shifter to replace my broken one in my Jinma 254.I cannot remember the correct position of the two slotted guide that the shift lever tang is guided by(bolts to the cover and sits over the shift lever spring and spring retainer).It will bolt in several ways but only works one way.Without all the trial and error can anybody tell me the correct mounting?Thanks,Don L

      • November 20, 2011 at 4:31 pm #33760
        donaldl
        Participant
          • Offline

          All right,As is often the case I corrected my own problem.The Farm Pro manual calls the plate I am having trouble with the “selector guide”.It can be positioned two different ways but only one way is correct.The correct mounting position is on the same side of the transmission cover that the dipstick hole is.I took a picture of it with my phone but service is terrible ,as usual .Will post that picture later.Don

        • November 21, 2011 at 10:22 am #33762
          Little_Grizzly
          Participant
            • Offline

            Thanks Don.  Although I don't own a Jinma I think pictures of situations like you have are very helpful to the others on the board.  Words can often be misunderstood but a good picture makes it obvious.

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.