fuel line bleeding

Forum › Forums › Tractor Troubleshooting › fuel line bleeding

Viewing 3 reply threads
  • Author
    Posts
    • July 1, 2024 at 7:36 pm #50251
      edsmtn
      Participant
        • Offline

        the easiest way to bleed a fuel line in y385t diesel engine in a 2004 jinma 284 tractor

      • July 1, 2024 at 7:43 pm #50252
        DavidPrivett
        Participant
          • Offline

          you will need to bleed it in two places , it should gravity bleed to the inlet of the injector pump ,but can be speed up by using the manual screw down knob on the lift pump helping it along, then at each injector on the cylinder head. if you have a decompression release use it and it will turn over faster and with less load on the battery. be carefull of the high pressure spray.

        • July 3, 2024 at 8:29 pm #50254
          edsmtn
          Participant
            • Offline

            my 2004 jinma 284 with a y385t diesel is cranking very sluggishly and slow. I’ve cleaned the battery terminals, charged the battery which didn’t help. Any suggestions.

          • July 4, 2024 at 1:51 pm #50255
            DavidPrivett
            Participant
              • Offline

              I have had good luck with adding a older style ford starter relay, and taking the load off the key switch that is wired on the small size gauge wise. there was a guy here a few months ago that did the conversion with good results. search the site here to see the details of it or if you are interested I can go over the method again. It is pretty easy to do.

          • Author
            Posts
          Viewing 3 reply threads
          • You must be logged in to reply to this topic.