Head gasket pushing oil

This topic has 2 replies, 3 voices, and was last updated 12 years, 5 months ago by Affordable.

Viewing 2 reply threads

Author

Posts
- May 14, 2012 at 8:18 am #30566
  CTOA
  Keymaster
  - Offline
  I overhauled my 284 and when i cranked it up, oil is pushing out between the head and block on the rear exhaust side. Any thoughts on what i did wrong? My eyesight is bad so maybe misinstalled head gasket?
  
  CTOA - Founder
- May 15, 2012 at 7:22 am #34600
  RichWaugh
  Participant
  - Offline
  Are you sure you had the correct gasket and that the block and head were both spotlessly clean before re-assembly? You didn't use any gasket sealer did you? Did you follow the correct torque sequence and torque to spec in stages?
- May 15, 2012 at 8:23 am #34601
  Affordable
  Participant
  - Offline
  You put the head gasket on upside down, once you take it off you will see where you blocked a hole at the rear.
  
  Tommy
  
  Affordable Tractor Sales
  
  “Your Jinma Parts Superstore”
  
  http://www.affordabletractorsalesco.com
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.