Jinma 354 clutch fingers replaced

Forum › Forums › Tractor Operation And Maintenance › Jinma 354 clutch fingers replaced

Viewing 2 reply threads
  • Author
    Posts
    • April 28, 2018 at 1:43 pm #47845
      jonesgrove
      Participant
        • Offline

        I was able to replace all 3 clutch fingers thru the side opening using long nose pliers to remove and replace the cotter pins from the pivot pins. Adjusted them all to the .100 clearance gap but now when I step on the clutch it squeals some. Should I have lubricated the ends of the fingers where they touch the bearing plate?

      • February 20, 2020 at 4:34 pm #49197
        jonesgrove
        Participant
          • Offline

          One article said he adjusted the clutch to a 10mm gap.  Isn’t that a lot bigger than the nominal .1″ gap that other forums mention?

        • February 21, 2020 at 6:51 pm #49198
          DavidPrivett
          Participant
            • Offline

            yes a tenth of a inch is  about 3 times smaller than 10mm,  it might have been a typo. error

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.