Jinma 354 Clutch installation

Forum › Forums › Tractor Operation And Maintenance › Jinma 354 Clutch installation

Viewing 2 reply threads
  • Author
    Posts
    • May 31, 2020 at 7:24 am #49349
      jonesgrove
      Participant
        • Offline

        Has anyone tried to install the clutch assembly by sliding it onto the shaft first and then bolting it to the flywheel after you bring the two halves of the tractor together?

      • May 31, 2020 at 12:40 pm #49352
        DavidPrivett
        Participant
          • Offline

          how would you get out the clutch alignment tool in or out or torque the pressure plate?? the access plate I believe is not near the  clearance you would need. or am I missing what you are saying?

          • June 5, 2020 at 5:56 pm #49371
            jonesgrove
            Participant
              • Offline

              there is enough room to reach in the side opening and screw the clutch bolts into the flywheel as you rotate it to each location as long as you already have them installed in the clutch holes. Still debating which way to go. Having trouble locating the alignment tool (out of stock at the places I called) anybody have one for loan?

          • June 5, 2020 at 7:52 pm #49373
            DavidPrivett
            Participant
              • Offline

              A automotive universal clutch tool might be available at a parts house, I am guessing it should work. All I have that way is some plastic ones of  unknown size and spline count.

          • Author
            Posts
          Viewing 2 reply threads
          • You must be logged in to reply to this topic.