Jinma 454 Broken Transfer Case for the Four Wheel Drive and gears

Forum Forums Tractor Troubleshooting Jinma 454 Broken Transfer Case for the Four Wheel Drive and gears

Viewing 3 reply threads
  • Author
    Posts
    • #45670
      homerj
      Participant
        • Offline

        Hey Guys,

        I got water in the rear end and it FROZE and I didn’t know. After a couple of attempts to move the tractor there was some snaps and bangs, and a while lot of oil. I broke the 4 wheel drive transfer case and broke a tooth off of a gear. Thats not the end of it! after further inspection I have gears broken in the drive gear box as well.

        Here is my question: What is the best and easiest way to break the tractor apart inorder to see all the damage and repair it? There must be folks out there that has tackled it before?

        I have a 2007 Jinma 454. no shuttle shift.

        Thanks

        Always Having a Time!

      • #45671
        Tinbender
        Participant
          • Offline

          Holy cow! Did your place get flooded? Before I start ordering parts I’d look for a used one with a blown engine, might save you time and money :unsure:

        • #45672
          DavidPrivett
          Participant
            • Offline

            looks like you got a engine that will power the sawmill or emergency generator you always wanted.

          • #45673
            kenotractors
            Participant
              • Offline

              I can get you any parts that you need, may have to special order some from China though.  But I do have that capability.  Do you have parts schematics for the tractor?  I have those also.  We have done this many times here at our shop.

              Another way to go about this is just order the whole transmission from China.  We have done this a few times.

              Let me know if I can help you out.

              Tyler Nystrom
              Keno Tractors
              parts@kenotractors.com
              866-363-8193
              Phone hours: M-F 8am to 5:30pm PST Sat 9am to 1pm PST

          Viewing 3 reply threads
          • You must be logged in to reply to this topic.