- This topic has 2 replies, 3 voices, and was last updated 9 years, 5 months ago by
.
-
Posts
-
-
I have a 2004 jm284. It used to jump out of reverse all the time. Now I have no reverse at all. I have disconnected the linkage and shifted by hand. Still no go, so it is not a limkage problem. Can I remove the plate on the right and check the shifting forks? Is there any trick to putting it back in? It I need to remove and rebuild the tranefer case., does anyone have the instructions for this? Any suggestions or ideas welcome.
Tom
-
Have you figured this problem out? If not i would take the top of your transmission off and see what is going on. It is very easy to remove the top plate, just take out all the bolts that are around your gear shifter and it will come right up and off. Also do you have 1st gear?
Trevor Nystrom
Keno Tractors
Parts Department
541-850-8193
866-363-8193
Tyler Nystrom
Keno Tractors
parts@kenotractors.com
866-363-8193
Phone hours: M-F 8am to 5:30pm PST Sat 9am to 1pm PST -
I take it this tractor has a shuttle shift ? If so it could be a broken pin in the side plate,or a bad cable, miss adjusted cable,or a bent fork.
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
http://www.affordabletractorsalesco.com
-
- You must be logged in to reply to this topic.