PTO on YTO X704 noisy

Forum › Forums › Tractor Troubleshooting › PTO on YTO X704 noisy

Viewing 2 reply threads
  • Author
    Posts
    • October 1, 2011 at 7:59 pm #30415
      Troysie
      Participant
        • Offline

        The PTO on my YTO X704 is making a loud bell-like noise , it began when tractor had 100 hrs at this time noise was not loud and seemed to be only happening when PTO had no load and was below working RPM, now at 340 hrs noise is loud enough to hear over tractor engine and is happening at the working RPM of the PTO. PTO has approximately 200 hours of working time on it .

         Any suggestions or recommendations appreciated.

          

      • October 3, 2011 at 10:00 pm #33311
        SpringValley
        Participant
          • Offline

          It sounds like something has been failing for some time.  The most likely suspect would be a bearing but that's a guess.  I would drain the oil and examine it for metal and other tell tail signs of failure.  At any rate you are going to have to tear into it to see what's going on.    Good luck.

        • October 10, 2011 at 2:50 am #33329
          cjimmybond
          Participant
            • Offline

            i had a sim problem. was broken teeth.

            also the bearings are high where there is no oil.

            can you send me picture of your rear end, need to see pto and back of housing.

            im not sure what your machine is but 9 out of 10 there the same.

            need a couple of pics as need to see what rear end, need to see in pics just under rear seat and half way down rear end.

            another pic showing me a the rear end so i can see the pto and around it.

            make sure they are good pictures.

            also does this have a 540 and 1000 rpm pto.

            you can email me the pics at cjimmybond@aol.com as i can never put pics on these sites lol

            remember i wont reply straight away as time difference so be a day behind.

            as its morning now and going to work.

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.