Forum Replies Created
-
Posts
-
All that is holding that in now is a bearing on the inside, if you can get something on either side of the big gear, and wiggle it out.the bearing on the end is sitting in a recessed area, it's not pressed in there
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
The Nortrac is the same as the Jinma 200 series, if you just need a tractor parts manual. If you want a set of manuals that includes the Parts, operation, Engine you need to know which engine you have ( Example Y385T )
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Take that 8 bolt cover off that the axle went thru, you will need to order a new driving shaft, bearing, 1/2 moon washer, gasket, seals, The driving shaft is pressed onto the bearing and the 1/ 2 moon washers.If you do not have a bearing press any local auto parts store can press the new one on for you.
We have all the replacement parts in stock., Do you have a parts book ? If not we have those also
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
We need to know what model number and name engine it has, we have several different water pumps in stock for the Chinese engines,very possibly have it.
As far as rebuilding it ? I don't think you are going to have much luck
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Most of the time what causes that seal to fail or blow out is a deadhead situation, keep a close eye on it
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
The solenoids are all different, we should have one that fits your tractor, we need to know the starter number. Some of the TY395 engines have the QD1315D starter
If you will send me a pic I'm sure we can get you fixed up
tommy@affordabletractorsalesco.com
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Take the 2- bolts out of the pump, both lines off the pump and the pump will come off. The pump driver is in the engine and should still be good.The new pump does not have to be bled it will purge the air out on its own, after you install the new pump make sure the hydraulic tank under the seat is full start the tractor and ork the loader and 3-point, recheck the fluid level CBN-314L 200 series
We have the new pumps in stock
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Sounds like the pump maybe dead heading ,loosen the bolts up on the pump the ones that hold the pump together ,see if that helps, if yes it could be your pump body is warped ?kit not installed correctly, ect. There are 2- different pump kits, one is thinner than the other
Also check your quick connects to make sure they are seated correctly
Tommy
Affordable Tractor Sales
“Your Jima Parts Superstore”
If you remove the cotter pin at the top, you can take a big straight screwdriver and take some of the slope out, then put the pin back in.They are adjustable,and if it's already worn out give us a call we have the replacements in stock
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Try this under Jinma Maint.
http://johnstractor.homestead……chAdj.html
It should help you
Tommy
Affordable Tractor Sales Co.
“Your Jinma Parts Superstore”
