Forum Replies Created
-
Posts
-
If you will drain the fuel tank,then take the fuel line, and the bottom of the bowl off (clear part), you can unscrew the fuel sediment bowl to replace it or see whats leaking.It will come off without removing the fuel tank
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
The book also used to say fill the radiator with clean creek water,I have been selling Jinmas since 2002 and none of them came with greasable throw out bearings, they use sealed bearings now.
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
We have every part you need for your tractor in stock including the replacement muffler, you can give us a call 979-865-4002 or visit our webpage, Parts center http://www.affordabletractorsalesco.com
Tommy
Affordable Tractor Sales Co.
“Your Jinma Parts Superstore”
Most of the time it is a bad quick connect coupling on one of the loader hoses
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
There are 3- different TY395 Engines, TY395I, TY395E-3, TY395 E-1,the parts are not all the same.You need to confirm Which engine you have first,I would also check the old Head gasket vs the new one very close, there is a difference.This same problem comes up with this engine SL3105 BT, and the SL3105 ABT both use some of the same parts but not all
You might have got a EPA head and a Non EPA block,or if your mechanic is confident the head is the correct one, get the parts supplier to send you a exhaust manifold
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
I have the GPM on the pumps at the shop, however it’s around 8.5 GPM on the E314 pump which is what your tractor has and plenty to run the backhoe.I also have a upgraded hydraulic pump CBN E-320 that will increase the GPM alot more if you needed it ,if it came with the tank already, we have the factory Backhoe pump that mounts above the PTO shaft on your tractor yo could use that too
Or if you have a Koyker loader, you can get the power beyond sleeve and hook up the backhoe thru that loader valve.
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Take the hose off ahead of it put the hose in a bucket, then take the fitting off.You will loose a “little hydraulic oil”
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
He was already helped on another chinese message board TBN,he got the shaft out, and ordered a new Transmission because it was cheaper and faster than rebuilding his
Here is the link
http://www.tractorbynet.com/fo…..ssion.html
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Well good for you, glad you got it going, I have heard of that happing but it is something to watch out for
Tommy
Affordable Tractor Sales Co.
“Your Jinma Parts Superstore”
True use a piece of wood.I have seen a few PTOs that just would not stop turning after they were disengaged but 90 % of them the PTO clutch needed to be adjusted
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
