Forum Replies Created
-
Posts
-
Glad we could help !!!!
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
I agree with the above, also if you check with Ronald at Ranchhand suppy 757-650-9124 he has a constant flow kit with brackets, hoses that will give you a supply and return at the rear of your tractor so you do not have to keep unplugging the loader,it's a ecoomical kit to purchase
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Check the oil in the transmission, there are 2- o-rings that seperate the Main clutch shaft and the PTO shaft, if the oil level is low it will make a squealing type of noise when you let out the clutch, You can overfill the transmission a little then drain it back down,if it is a release bearing it would make the noise while the clutch is engaged also
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Call Ranchhand supply 757-650-9124, he has the new after market valve, new mounting bracket,6- new hoses,and in less than 2-hours you are back up and running
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
There is a adjustment under the tractor that has a trnbuckle to adjust the amount the linkage can move,you need to adjust that linkage in or out to get enough movement in each direction
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
Happy Holidays to Everybody, we appreciate all of you and the business we have received throughout the year from this site
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
We have a very large Foton & Jinma Parts supply, Call the shop with the clutch size ( They put different size clutchs in the tractors,) 979-865-4002 and we will see if we can help you, last count we had about 150 different clutchs in stock
Tommy
Affordable Tractor Sales Co.
“Your Jinma Parts Superstore”
It could be a stuck thermostat ? or if you look thru your radiator from the front of the tractor are the fins must be clean enough to see thru ,if not you need to do more cleaning ? Make sure the oil is clean and not milky that would indicate water in the oil which could be a head gasket.
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
The tach sender screws into the Bell housing, with the dozer NOT running,loosen lock nut screw in until it touchs,back off a half a turn and resecure.If that des not get it going again it could be a bad tach, bad sender, or wire
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
On the lower side of the oil sump , kinda of right below the oil filter if it's a Y380
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
