clayton991

Forum Replies Created

Viewing 10 posts - 1 through 10 (of 15 total)
  • Author
    Posts
  • in reply to: Safety wired knob on injector pump? #38007
    clayton991
    Participant
      • Offline

      Well, that's too bad because my “mechanic” unwired it and turned it back and forth to see if it affected the slightly rough running engine. It did help a little. I guess I'll just wire it where it runs the best. Thanks

      in reply to: Injector Removal #37886
      clayton991
      Participant
        • Offline

        Alright. Yeah, its stuck pretty good. I have new copper washers. Ok, that injector is coming out tomorrow. Thanks

        in reply to: Injector Oil service #37857
        clayton991
        Participant
          • Offline

          No no no. Not gas.  I think I overfilled the oil after someone told me to just “fill it till it runs out”…..I didn't know about the overflow down below, I thought they meant the filler port so I put in about 1/2 a quart. Now, some oil did drip out of the little overflow banjo tube (plastic cover off), but not nearly the excess amount I put in. I ran the tractor for a couple of hours. Then I opened the filler cap again and dipsticked it with a little screwdriver and its all the way down to 1/2 an inch. Where did all that oil go? I opened the overflow banjo nut this morning and nothing came out.

          My real question is….could that excess oil have mixed with the gas going thru the injector pump?? The engine is running rough and I'm thinking injectors are gummed up.

          in reply to: fuel injector specs #37854
          clayton991
          Participant
            • Offline

            Did you ever get this resolved? Sounds like my problem.

            in reply to: Injector Oil service #37853
            clayton991
            Participant
              • Offline

              Ok. I did fill passed that point and the overflow is spitting some out. And, its not running that good either. Oil in the gas?

              in reply to: Injector Oil service #37850
              clayton991
              Participant
                • Offline

                Ok. Nut cap. Got it filled up. Definitely needed oil. Running better. Still rough in the higher RPMs but not too bad. Injectors need cleaning next. Thx

                in reply to: Injector Oil service #37849
                clayton991
                Participant
                  • Offline

                  Been looking at picks of new ones. Looks like it is a nut cap. The vent is the top part, nut on the bottom. Will try that.

                  in reply to: Injector Oil service #37848
                  clayton991
                  Participant
                    • Offline

                    Been looking at picks of new ones. Looks like it is a nut cap. The vent is the top part, nut on the bottom. Will try that.

                    in reply to: Injector Oil service #37847
                    clayton991
                    Participant
                      • Offline

                      Of course its packed with dirt up around it. I've made a little tool to get up around it and scrape it out, but its still just spinning. Its a vent so I don't want to use water.

                      in reply to: Injector Oil service #37846
                      clayton991
                      Participant
                        • Offline

                        Thank you Jmayo and Ron.

                        Ron, the picture shows the cap as vent and fill cap.  Other than spinning left and right I can get no motion up and down to remove. Have you ever removed one? Is the cap supposed pop up or unscrew or? I need to know before I put some real muscle into it. Don't want to break it.

                        Thanks

                      Viewing 10 posts - 1 through 10 (of 15 total)