fzr1000

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Jinma 354 three point hitch arms do not respond #47089
    fzr1000
    Participant
      • Offline

      Thanks for replying back so quick.
      The front end loader has quick disconnect hoses and it seems to function fine, so I’m thinking the hyd pump is working ok since it’s a closed loop system. I’ve played around with the hyd adjustment knob under the seat with no reaction. I can pretty much just lift the arms up with no real resistance from the actuator.
      I’ve changed the fluid and looked inside the top cover under the seat and don’t see anything really amiss but apparently there is.
      Do you happen to know how the three point hitch has fluid ported to the actuator? I didn’t hear any noise or anything even trying to move when I was running the tractor and listening for activity
      Thanks, Scott :unsure:

      in reply to: Exhaust stack #47001
      fzr1000
      Participant
        • Offline

        I tried doing that at a local exhaust shop that had welded up the cracks in it several times, but they said they didn’t have that kind of pipe size to make a new one. But I’ll try a different shop and see if they can do it instead.
        Thanks

        in reply to: Leaking lift arm seal #35249
        fzr1000
        Participant
          • Offline

          Ok the seal size is 52×5.7 according to the manual. Sound right?

          in reply to: Leaking lift arm seal #35237
          fzr1000
          Participant
            • Offline

            The part number out of the book for those is GB 1235-1976. If you have those in stock I suppose it would be wise to replace both sides then? Haven’t checked for excess play in the bushings yet. Are those difficult to change? Do they have to be pressed in?

            in reply to: Leaking lift arm seal #35235
            fzr1000
            Participant
              • Offline

              Ok, will do. I’ll have to get the part numbers out of the IPC first, but is this something that you would normally carry in stock?

              in reply to: Leaking lift arm seal #35231
              fzr1000
              Participant
                • Offline

                Thanks for that. I do have a parts book for it, and will check the illustrated breakdown. Are they difficult seals to replace? Or do you just remove and replace them when you pull the lift arm off?

              Viewing 6 posts - 1 through 6 (of 6 total)