Glenn Southworth

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: BACK HOE NOT WORKING #36255
    Glenn Southworth
    Participant
      • Offline

      ok. Thanks for the help guys!

      in reply to: BACK HOE NOT WORKING #36240
      Glenn Southworth
      Participant
        • Offline

        I have oil leaking into the spring area. Im thinking those are seals just above the spring? The orings should be easy to get but the other ones look like squared orings? Do they make kits or where can I get them. Thanks

        in reply to: BACK HOE NOT WORKING #36238
        Glenn Southworth
        Participant
          • Offline

          Got it working. Think the valve was stuck. You were right the hoe was off the tractor and i took the back cover off so the valve was on the right. Now that its working the  the  control valve for the boom is leaking out the botom cup. I figure the seal is gone. Can you buy rebuild kits for those or do you need to buy the whole valve assembly? Im going to take the valve out tomorrow and see what it looks like.

          in reply to: BACK HOE NOT WORKING #36224
          Glenn Southworth
          Participant
            • Offline

            I took one out that looks like that on the right side….but I don't think I got it all I think the “piston” with the o ring is still in there. Maybe that is stuck. Its raining now but I will look at the left again to see if I missed it tomorrow. Thanks for the picture that will be helpful.

            in reply to: BACK HOE NOT WORKING #36222
            Glenn Southworth
            Participant
              • Offline

              Yes that's what I was talking about. I took out the valve on the right…looks like its too adjust the pressure . Didn't see any dirt

              in reply to: BACK HOE NOT WORKING #36220
              Glenn Southworth
              Participant
                • Offline

                I don't think its sucking air it wont do anything.Stabilizers wont even go down. I am not sure what valve people are cleaning and where it is. It just seems to be circulating and not building any pressure at all. What holds the pressure in the valvebody of the controls? Thanks for the idea though I will check again.

              Viewing 6 posts - 1 through 6 (of 6 total)