mag

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 11, 2019 at 6:54 pm in reply to: PTO not disengaging #49137
    mag
    Participant
      • Offline

      I have a chipper installed

      October 11, 2019 at 5:08 pm in reply to: PTO not disengaging #49135
      mag
      Participant
        • Offline

        yes the PTO runs all the time except when I step on the clutch. I don’t think it is the roll pin, I can feel the shaft rotating.  Why would it spring back from EN to DIE?  Yes I have a parts diagram

        July 12, 2017 at 3:21 pm in reply to: Hydraulic pump problem #47080
        mag
        Participant
          • Offline

          New pump, new filter, added gauge and external relief valve. At present both the external relief valve and the FEL valve are set at 2ooo psi.  Anyone see a problem with them both relief valves set at the same psi ?

          July 11, 2017 at 5:58 pm in reply to: Hydraulic pump problem #47078
          mag
          Participant
            • Offline

            A new pump will arrive soon and I am installing a external relief valve at the out put of the pump set a little higher than FEL relief. I am also installing a gauge to keep an eye on pressure.  So I shouldn’t blow the pump anymore.

            July 10, 2017 at 8:04 am in reply to: Hydraulic pump problem #47075
            mag
            Participant
              • Offline

              Forgot to mention it’s a jinma 284.  I didn’t find a problem last time just rebuilt the pump.  No quick disconnect connectors so what would cause dead head

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)