Forum Replies Created
-
Posts
-
Griz
See hydraulic system mods in https://en.wikibooks.org/wiki/Chinese_Tractor_Maintenance/Dozer#Modifications
Think two copper penny like flat disks with 1/16″ holes. (Assume you are concerned about blade tilt.)
Phil
Bob, I have steel tracks. Always used on dirt so no need to spend the extra 1K to get rubber tracks. Phil
Just measured my pins for “HX” castings. Pin diameter was 20-21mm and center to center was ~4 1/3 inches. I assume I have style 1 tracks.
Did you email Yuchai?
I am unable to easily count the teeth on my idler but notice both my idler and drive sprocket castings have a HX on them. Try emailing parts@ycexavator.com for information you seek. In the past they have been very helpful.
I suspect that what you are looking at is track ware and at some point in time you will have to remove a track link. Just so you know, Bob Rooks is my ” go to guy”.
Phil
Pre-filter: WIX 33972
Filter: Racor 025-RAC-02. Recommended by Bob Rooks. Has S2502 element which separates water from fuel.
Phil
I have the dozer with 395T engine. dual phase biocide treats both the water and diesel. I use Bio Kleen from Power Service. Recommend you read information on their site.
Will have to get back with you on filters.
Phil
I have had a bug problem that stopped me dead on the side of a hill. Finally removed bowl and all screens replacing with a pre-filter and filter that were easy to change.
My first biocide was from West Marine and found out the hard way that the biocide must be dual phase. Now I treat all my new diesel and do quarterly maintenance on all diesel in storage.
