Forum Replies Created
-
Posts
-
HOORAY!!!!!! I found a soft cab made to fit my tractor from Keno tractor.Less than 300.00 shipped to my door.
Thanks Dave ,all the wires are there but I imagine the bulbs are shot.I am going to replace all of them with led lights.Tractor supply has loads of them on clearance now.Freezing rain here at the moment so I will wait for spring.
Took the tractor out pushing snow yesterday.What a tank it is but I need a cab for it.Also figured out the canopy light switch. It’s built into the turn signal handle you just turn the handle.I will wait for a day above -10 to get the lights working though.
Depending on the wear you can go to a bearing dealer and get a sleeve to replace your worn material.If you know a machinist they could build you a bushing to fix it also.
My tractor had this problem and it was a blown pump seal.My mine has 2 pumps one for the steering and one for the hydraulics the hydraulic pump is the rear one on mine.Also the hydraulic reservoir is on the top of the transmission under your seat.
These pumps are available on eBay for cheap just look up Bosch priming pumps.I had to replace one on my komatsu d-21 loader it just threaded in to the pump.
Yep it’s the priming pump if your tractor is running fine don’t mess with it.Only use it if you are changing filters or run out of fuel.
Update to my update:After several calls I have determined my Ranch Hand tractor to be a Foton TB 454 model.I also fixed my shuttle shift after it finally warmed enough to crawl under the tractor.It had loose mounting bolts on the shift mounting bracket.This part is apparently designed to fail so my machinist nephew and I are going to try to design a lower mount to help stabilize the shifter mechanism.Here is the parts blow up of my shuttle shifter.
