Charles Leonard

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • November 27, 2014 at 6:13 pm in reply to: loosing antifreeze #37360
    Charles Leonard
    Participant
      • Offline

      Thanks pjr for the info. i will try this but at a little bit later , again thanks          Wayne1971

      November 27, 2014 at 6:10 pm in reply to: loosing antifreeze #37359
      Charles Leonard
      Participant
        • Offline

         Thanks Tinbender thats what i thought but i like to ask questions before  i try to fix something like this.                           Wayne1971

        November 27, 2014 at 6:06 pm in reply to: loosing antifreeze #37358
        Charles Leonard
        Participant
          • Offline

          The 295T 2 cylinder  engine came in the Taishan 1991 that i have and also in a 1994 4×4 25 hp tractor that i have.                     wayne1971

          October 26, 2014 at 2:53 pm in reply to: engine fuel pump timing #37309
          Charles Leonard
          Participant
            • Offline

            Thanks Bob. I think I have figured it out 

            September 17, 2014 at 7:28 pm in reply to: transfer case idler gear and clutch disk assembly #37235
            Charles Leonard
            Participant
              • Offline

               Tommy, here is a picture of the clutch disk, this is a single stage clutch 9″ 6 spline. thank you,   Wayne 1971

              Thanks, 

              Wayne

              September 9, 2014 at 7:11 pm in reply to: clutch disc rivets #37211
              Charles Leonard
              Participant
                • Offline

                thanks for the information Tommy. I will give chip a call

                April 11, 2013 at 4:47 pm in reply to: 4WD Won’t stay in gear #35936
                Charles Leonard
                Participant
                  • Offline

                  David, I checked and my tractor does not have a  tension bolt that I can find . it have a fork shaft locking spring but no adjusting bolt.

                  April 11, 2013 at 9:46 am in reply to: 4WD Won’t stay in gear #35934
                  Charles Leonard
                  Participant
                    • Offline

                    I am not sure if it has a adjusting bolt for tension the pressure spring or not, but I will check  to be sure. thanks     Wayne 1971

                  • Author
                    Posts
                  Viewing 8 posts - 1 through 8 (of 8 total)